3/4″ Magnetic Snaps

1. Mark position of snap pieces by pressing prongs into fabric and forming an indention.
2. With very sharp scissors, cut slits (at indentions) wide enough for prongs to slide through. Insert snap into slit from right side of fabric.
3. To prevent metal support from cutting fabric, place a piece of lightweight cardboard (slightly larger than metal support) over the metal prongs on the wrong side of the fabric.
4. Slide the metal support over the cardboard. Use pliers to bend the prongs flat over the metal support.

WARNING: This product contains (a) small magnet (s). Swallowed magnets can stick together across intestines causing serious infections and death. Seek immediate medical attention if magnet(s) are swallowed or inhaled. CHOKING HAZARD: Small parts. Not for children under 3 years.

For supplemental instructions, refer to the following files:

ApplyingMagneticSnapsWithProngs.pdf